MacMusic  |  PcMusic  |  440 Software  |  440 Forums  |  440TV  |  Zicos
room
Search

New Technology Delivers Power To Electronic Devices in a Test Space

Friday September 3, 2021. 08:44 PM , from Slashdot
What if your smartphone or laptop started charging as soon as you walked in the door? Researchers have developed a specially built room that can transmit energy to a variety of electronic devices within it, charging phones and powering home appliances without plugs or batteries. Scientific American: This system 'enables safe and high-power wireless power transfer in large volumes,' says Takuya Sasatani, a project assistant professor at the University of Tokyo's Graduate School of Engineering and lead author of the new study, which was published this week in Nature Electronics. The room relies on the same phenomenon as short-range wireless phone chargers: a metal coil, placed in a magnetic field, will produce an electric current. Existing commercial charging docks use electricity from a wall outlet to produce a magnetic field in a small area. Most recent smartphones are equipped with a metal coil, and when such a model) is placed on the dock, the interaction generates enough current to power the phone's battery. But today's commercial products have a very limited range. If you lift a phone off the dock or swathe it in a case that is too thick, the wireless power transfer ceases. But if a magnetic field filled a whole room, any phone within it would have access to wireless power.

'The prospect of having a room where a variety of devices could just receive power anywhere is really compelling and exciting,' says Joshua Smith, a professor of computer science and electrical engineering at the University of Washington, who was not involved in the new study. 'And this paper takes another step toward making that possible.' In the study, the researchers describe a custom test room of about 18 cubic meters (roughly equivalent to a small freight container), which Sasatani built from conductive aluminum panels with a metal pole running down the middle. The team furnished the room with a wirelessly powered lamp and fan, as well as more prosaic items, including a chair, table and bookshelf. When the researchers ran an electric current through the walls and pole in a set pattern, it generated a three-dimensional magnetic field within the space. In fact, they designed the setup to generate two separate fields: one that fills the center of the room and another that covers the corners, thus allowing any devices within the space to charge without encountering dead spots.

By carrying out simulations and measurements, Sasatani and his co-authors found their method could deliver 50 watts of power throughout the room, firing up all of the devices equipped with a receiving coil that they tested: a smartphone, a light bulb and a fan. Some energy was lost in the transfer, however. Delivery efficiency varied from a low of 37.1 percent to a high of about 90 percent, depending on the strength of the magnetic field at specific points in the room, as well as the orientation of the device. Without precautions, running current through the room's metal walls would typically fill it with two types of waves: electric and magnetic. This presents a problem, because electric fields can produce heat in biological tissues and pose a danger to humans. So the team embedded capacitors, devices that store electric energy, in the walls. 'It confines the safe magnetic fields within the room volume while confining hazardous parts inside all the components embedded inside the walls,' Sasatani explains.

Read more of this story at Slashdot.
rss.slashdot.org/~r/Slashdot/slashdot/~3/uiMJSBlpHZw/new-technology-delivers-power-to-electronic-dev...
News copyright owned by their original publishers | Copyright © 2004 - 2024 Zicos / 440Network
Current Date
Mar, Thu 28 - 09:15 CET